I- 00162 Page 4 of 7
CABLE MANAGEMENT
1) Determine direction of rack rotation
and wire this way. Select one side of
rack for signal cables, and the
opposite side for power cables.
Fully extend rack and rotate 90o as
shown. Lace cables as shown,
ensuring cables are fairly taut.
This ensures that the service loop
will be the correct length and not be
pinched when closing the rack.
NOTE: The rack will only rotate in
the direction originally selected
when cabling is complete.
PROPER METHOD OF
FASTENING CABLES
USING WIRE TIES
(HINT - LEAVE THIS
LOOSE)
FASTEN CABLES
APPROXIMATELY
3" FROM END
SHOWN EXTENDED AND ROTATED WITH
TWO SETS OF WIRES FOR CLARIFICATION
SRSR ROTATING SLIDING RAIL SYSTEM
instructions
REAR
RACKRAIL
To rotate, pull rotating tab. Bay conveniently locks from center position at 60o and 90o to
keep open in service position, and at 0o to orient for closure. To slide closed, first push down the
lockout lever.
ROTATING
TAB
Cable Management Tip:
Tie your cable bundles at least every 6" - 8".
This allows cable bundles to lay neatly
together when rack is in the closed position.
LOCKOUT
LEVER
