TEMPERATURE PROBE INSTALLATION
If using a THERM-A (See pg 8) disregard this page and refer to the instructions included
with the THERM-A.
1) Determine what location the probe will be placed in the equipment room. Mount at the
highest possible location.
NOTE: It is recommended that the Temperature Probe is placed away from the Intake Assembly to
properly gauge temperature.
See FIGURE A for an example of a Temperature Probe Assembly installation.
2) Drill a 1/8" hole where the Temperature Probe (M) will be located.
3) Run Temperature Probe Wire along joist and secure with provided Wire Ties (L), Wood Screws (J)
and Cable Tie Mounts (G). Place Probe lead through previously drilled 1/8" hole.
4) If desired cut the stripped ends of the Temperature Probe Wire to appropriate length.
Strip approximately 1/16" from each lead.
5) Insert stripped ends of Temperature Probe leads into Connector (K)
Page 6
