Middle Atlantic Products Cool Series Instruction Sheet Download Page 5

Page: 5 / 8

1) Install Fan Unit (B) to Mounting Plate (C) using provided hardware (F & H). Use a Phillips Head

Driver and 3/8" Wrench (mount in four places). (FIGURE A)

FAN UNIT INSTALLATION

NOTE: Mount flange up.

FIGURE A

NOTE: Fan Unit can mount on Mounting Plate in two directions, adjustable slots allow

for two inch shift either way off center position. (FIGURE B)

2) Determine mounting location in attic. (Mounts to joists or structurally sound flat surface)

NOTE: Make sure airflow faces away from Louvered Intake (airflow shown on label affixed to

fan unit and on electrical box).

3) Mount Fan Unit as desired using customer supplied hardware. (FIGURE C)

Page 5

Summary of Contents for Cool Series

Page 1: ...d these instructions thoroughly before installing assembling this product PRODUCT FEATURES Removes air from enclosed areas with minimal noise Inline mixed flow duct fan is quieter and more efficient than centrifugal fans Operates only when needed minimizing noise and dust M iddle Atlantic Products I 00248 Rev C ...

Page 3: ...BLE DUCT CLAMPS QTY QTY PART D PART E 1 3 10 32 x 1 2 PHILLIPS HEAD SCREW QTY PART 5 F CABLE TIE MOUNT QTY 12 10 32 LOCKNUT TEMPERATURE PROBE CONNECTOR TEMPERATURE PROBE WIRE 30 FEET QTY PART 5 One Extra One Extra H QTY PART 1 K QTY PART 1 M 10 x 5 8 WOOD SCREW QTY 12 WIRE TIE INTAKE TEMPLATE QTY 24 QTY 1 Page 3 PART G PART J PART L PART N ...

Page 4: ...te to mark installation location NOTE Hole size is 7 1 8 3 Cut hole using desired method hand saw power saw etc FIGURE A INTAKE ASSEMBLY INSTALLATION 4 Insert Intake Assembly A into the hole FIGURE B 5 Tighten the four screws on the Intake using a Phillips Head screwdriver The clips will automatically swing into the proper position securing the Intake Assembly FIGURE C ...