Installation and Service Instructions
1107
8471 50
Printed in U.S.A.
Economite
RE4400DS HTD
Gas Burner
Midco
®
International Inc.
4140 West Victoria St. - Chicago, Illinois 60646
tel 773.604.8700 fax 773.604.4070
web www.midcointernational.com e-mail [email protected]
Q u a l i t y D e s i g n e d f o r P r o v e n P e r f o r m a n c e
In the United States,
Installation must conform
with local codes or, in the absence of local codes, with
Installation of the
National Fuel Gas Code, ANSI Z223.1-
latest edition,
from the American National Standard Institute.
Further reference should be made to the recommendation of
your fuel supplier.
In Canada
, Installation must conform with local
codes or, in the absence of local codes, with
Installation
Codes for Gas Burning Appliances and Equipment, CGA
Standard CAN/CGA 1B-149
. Further reference should be
made to the recommendation of your fuel supplier.
WARNING: Additions, changes, conversions, and
service must be performed by an authorized MIDCO
representative, service agency, or the fuel supplier. Use
only MIDCO specified and approved parts.
INSTALLER: Inform and demonstrate to the user the
correct operation and maintenance of the gas utilization
equipment. Inform the user of the hazards of storing
flammable liquids and vapors in the vicinity of this gas
utilization equipment and remove such hazards. Affix
this manual and associated literature adjacent to the
burner. CODE COMPLIANCE IS THE SOLE
RESPONSIBILITY OF THE INSTALLER.
USER: Retain this manual for future reference. If other
than routine service or maintenance as described in this
manual and associated literature is required, contact a
qualified service agency. DO NOT ATTEMPT REPAIRS.
An inadvertent service error could result in a dangerous
condition.
FOR SERVICE CONTACT:
Name
Address
Phone
Date of Installation
Do not store or use gasoline or other flammable vapors and
liquids in the vicinity of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance.
Do not touch any electrical switch;do not use any
phone in your building.
Immediately phone your gas supplier from another
building. Follow the gas supplier’s instructions. If you
cannot reach your gas supplier call the fire department.
Installation and service must be performed by a
qualified installer, service agency or the gas supplier.
WARNING
: If the information in these instructions
is not followed exactly, a fire or explosion may result,
causing property damage, personal injury or death.
Burner Model
Bill of Material #
Serial Number
Wiring Diagram
AVERTISSEMENT.
Assurez-vous de bien suivre
les instructions données dans cette notice pour
réduire au minimum le risque d’incendie ou
d’explosion pouvant entraîner des dommages
matériels, des blessures ou la mort.
S A F E T Y I N F O R M A T I O N T E R M S :
The following terms are used to identify hazards, safety precaution of special
notations and have standard meanings throughout this manual. They are printed in all capital letters using a bold type face
as shown below, and preceded by the exclamation mark symbol. When you see the safety alert symbol and one of the
safety information terms as shown below, be aware of the hazard potential.
DANGER
: Identifies the most serious hazards which
will
result in severe personal injury or death.
WARNING
: Signifies a hazard that
could
result in personal injury or death.
CAUTION
: Identifies unsafe practices which would result in minor personal injury or product and property damage.
Ne pas entreposer ni utiliser d’essence ni d’autres
vapeurs ou liquides inflammables à proximité de cet
appareil ou de tout autre appareil.
QUE FAIRE SI VOUS SENTEZ UNE ODEUR DE GAZ:
• Ne pas tenter d’allumer d’appareil.
• Ne touchez à aucun interrupteur. Ne pas vous servir des
téléphones se trouvant dans le bâtimentoù vous êtes.
• Appelez immédiatement votre fournisseur de gaz depuis
un voisin. Suivez les instructions du fournisseur.
• Si vous ne pouvez rejoindre le fournisseur de gaz,
appelez le service des incendies.
L’installation et l’entretien doivent être assurés par un
installateur ou un service d’entretien qualifié ou par le
fournisseur de gaz.
