Microwave Data Systems iNET 900 Series, User Manual

Page: 72 / 180

64 MDS iNET 900 Series User’s Guide MDS 05-2806A01, Rev. E.1
3.6.4 Configuring for TCP Mode
Invisible place holder
Figure 3-28. TCP Client Menu (Remote)
•
Status
—Enable/Disable the serial data port.
•
IP Protocol
—TCP Client. This is the type of IP port that will
be offered by the transceiver’s serial device server. [
TCP, UDP,
PPP; TCP
]
•
Primary Host Address
—The IP address to be used as a destina-
tion for data received through the serial port.
[
Any legal IP address; 0.0.0.0
]
•
Primary IP Port
—The destination IP port for data packets
received through the serial port on the transceiver.
[
Any valid IP port; COM1: 30010, COM2: 30011
]
•
Secondary Host Address
—The IP address to be used as a desti-
nation for data received through the serial port in case the pri-
mary host address is not available.
[
Any legal IP address; 0.0.0.0
]
•
Secondary IP Port
—The destination IP port for data packets
received through the serial port on the transceiver used along
with the secondary host address above.
[
Any valid IP port; COM1: 30010, COM2: 30011
]
•
Outgoing Connection’s Inactivity Timeout
—Amount of time (in
seconds) that they transceiver will wait for data before termi-
nating the TCP session. [
0–600; 600
]
•
Data Baud Rate
—Data rate (payload) for the
COM
port in
bits-per-second. [
1,200–115,200; 19200
]
•
Configuration
—Interface signaling parameters. Data bits, par-
ity and stop bits
[
7N1, 7E1, 7O1, 8N1, 8E1, 8O1, 8N1, 7N2, 7E2, 7O2, 8N2, 8E2, 8O2;
8N1
].
•
Flow Control [Com2 Only]
—RTS/CTS handshaking between
the transceiver and the connected device.
[
Enable, Disable; Disabled
]