MDS 05-2806A01, Rev. E.1
MDS iNET 900 Series User’s Guide
19
2.1
OVERVIEW
It is best to set up a tabletop network that can be used to verify the basic
operation of the transceivers and give you a chance to experiment with
network designs, configurations or network equipment in a convenient
location. This test can be performed with any number of radios.
When you are satisfied that the network is functioning properly in a
bench setting, field installation can be performed. Complete information
for field installation, including mounting dimensions and antenna selec-
tion, is provided in
INSTALLATION PLANNING on Page 129
For the following evaluation, one of the transceivers in the network must
be set to Access Point service (
Device Mode = Access Point
) for proper
operation.
NOTE:
It is important to use a “Network Name” that is different from
any currently in use in your area during the testing period. This
will eliminate unnecessary disruption of traffic on the existing
network while you become familiar with the transceiver or
evaluate variations of unit operating parameters.
To simulate data traffic over the radio network, connect a PC or LAN to
the Ethernet port of the Access Point and PING each transceiver several
times.
2.2
STEP 1—INSTALL THE ANTENNA
CABLING
Figure 2-1
is a drawing of the tabletop arrangement. Connect the
antenna ports of each transceiver as shown. This will provide stable
radio communications between each unit while preventing interference
to nearby electronic equipment from a large number of co-located units.
Invisible place holder
Figure 2-1. Typical setup for tabletop-testing of radios
POWER ATTENUATORS
• Fixed or adjustable
• 1W Minimum Rating
POWER DIVIDER
NON-RADIATING ATTENUATORS
• Install on unused divider ports (if any)
• 1W Minimum Rating
COMPUTER
LAN
COM1
COM2
PWR
LINK
LAN
COM1
COM2
PWR
LINK
Remote
Remote
Access Point
Remote
Summary of Contents for iNET 900 Series
