Note:
These operating instructions are part of the device and must be available to the user at all
times. The safety instructions contained therein must be observed.
WARNING:
It is strictly prohibited to disable the safety equipment or modify its mode of operation.
4.9 Installation of spare and wear parts
Be advised that spare and accessory parts that have not been supplied by the manufacturer have also not
been inspected or approved by the manufacturer. The installation and/or use of such products can possibly
have a negative impact on the specified constructional properties of the device. The manufacturer shall not be
liable for any damages that arise from the use of non-original parts and non-original accessory parts.
4.10 Storage of the product
For safekeeping of the myDatalogEASY IoTmini , ensure that all relevant data was transferred to the
myDatanet server. If necessary, initiate a transmission directly on the device using the solenoid contact (see
"Solenoid switch" on page 71), if you have included this in your Device Logic, and then check again to see
whether all of the relevant data has now been transferred. If your device does not include the option to initiate
the transmission of temporarily stored measurement data, you may have to wait until the next scheduled data
transmission for all of the data to be sent to the myDatanet server. Remove the power supply unit before
disconnecting the cables and antenna. If possible, switch off the supply or charging voltage before
disconnecting the cables from the V IN and GND clamps (see "Connecting the sensors, actuators and power
supply" on page 50). Store the myDatalogEASY IoTmini and power supply unit in the original packaging.
The configuration and most recently determined data are retained. The system time also continues to run
thanks to the hardware real-time clock equipped with its own buffer battery. This means that a valid time basis
is available immediately following recommissioning (see "Technical details about the system time" on page
65).
4.11 Warranty
The device has been functionally tested before delivery. If it is used as intended (see "Intended use" on page
22) and the operating instructions, the applicable documents (see "Applicable documents " on page 67) and
the safety notes and instructions contained therein, are observed, no functional restrictions are to be
expected and perfect operation should be possible.
Note:
Please also note in this regard the next chapter "Disclaimer" on page 25.
Note: Limitation of warranty
In the event of non-compliance with the safety instructions and instructions in this document, the
manufacturer reserves the right to limit the warranty.
24
Rev. 01