Microtronics BLE mA Link, User Manual, Page: 29 / 46

Chapter 8 Initial Start-Up
Chapter 8 Initial Start-Up
8.1 User information
Before placing the BLE mA Link into operation, you must observe the following user information!
This manual contains all information that is required for using the device.
It is intended for technically qualified personnel who have the relevant knowledge and experience in the area
of measurement technology.
Read this manual carefully and completely in order to ensure the proper functioning of the BLE mA Link .
Please contact our technical department if anything is unclear or if you encounter difficulties with regard to
installation or operation (see "Contact information" on page 45).
If necessary, please also refer to the manuals of the accessory parts when commissioning the complete
system. These manuals are included in the scope of delivery of the accessory parts.
8.2 General principles
The entire measurement system must only be placed into operation after completion and inspection of the
installation. Study the manual thoroughly before placing into operation.
8.3 Commissioning the system
No special commissioning process is required for the BLE mA Link . As the instrument does not have a
transport mode, it is possible to establish a connection with a compatible data logger
(e.g.myDatasensH2S1000 BLE/3G ATEX ) at any time via Bluetooth Low Energy. To do so, the serial
number of the BLE mA Link must be entered in the "Output channels" configuration section of the relevant
data logger. A detailed explanation of this is available in the manual of the relevant data logger. Once both of
the devices have been coupled successively, the BLE mA Link starts to issue the current values received from
the data logger via the Bluetooth connection (Bluetooth Low Energy). It is recommended that the BLE mA
Link is first placed into operation in the office before moving the device to the place of use. Take the
opportunity to get to know the functions of the device in a stable environment.
8.4 Testing communication with the device
Note: A detailed explanation of the operation (solenoid switch, display) is available in the manual of
the relevant data logger.
1. Enter the serial number of the BLE mA Link that is associated with the required logger in the "Output
channels" configuration section of the site (see "Output channels" on page 32).
2. To establish a connection, activate setup mode on the required data logger using the solenoid switch
(press and hold for three seconds). The configuration of the site (incl. the serial number of the BLE mA
Link ) is transmitted to the data logger during this process.
Rev. 01 29