2
1.4 Connecting the Tester Table to the High Voltage Output Terminal
While the tester is off, connect the high voltage tester cables to the high voltage
output terminal of the tester and make sure that there are no ruptures outside
the cables and that the cables are not loose.
1.5 Warm-up
The instrument will operate normally upon starting the power. To achieve the
specified accuracy, it is suggested warming up the instrument for over 15
minutes.
1.6 External control unit
This unit is able to execute the external control. For this purpose, please ensure
that the operator is not touching the signal output end and the Test Piece to
avoid causing hazard.
1.7 Machine failure
Stop using the instrument immediately when finding it is operating abnormally,
such as significant difference is existed between the current displayed on the
current meter and the design value; or the current is not supplied, but the
overlapping current indicator remains illuminated continuously. In this case,
please contact us or your dealer to provide technical support.
1.8 Ending the test
When not using the instrument, please shut off the Power Switch. To restart the
Power Switch after being disconnected, please wait for few seconds; however,
