8
ArtixScan 1100 Hardware User’s Guide
English
B. Installation for the new G3 Macintosh computers (without built-in SCSI ports)
1. Installing the interface card
Before installing the interface card, make sure you turn
off your computer and peripherals. Then follow the steps
below:
1.
Shut down your computer and unplug the power
cord. Next, open your computer.
2. Look for an available PCI card slot (typically white
or ivory) in your computer. Remove the slot cover,
and insert the Adaptec PCI SCSI card into the slot.
Push the card in to make sure it is seated all the way
in the slot. This is important, as an improper card
connection will make you unable to use your scanner,
and you will then have to remove the computer case
and reinsert the card.
3.
Close the computer, then plug the power cord back
in.
2. Connecting the scanner
1.
Shut down your computer.
2.
Connect the scanner to your computer, using the SCSI
cable provided in the scanner package.
Note: See the next section for details on termination.
3.
Plug the power cord to the power connector at the
back panel of the scanner, and plug the other end of
the power cord to your AC power source or wall
outlet.
4.
Turn on your scanner and wait for the lights on the
front panel to stop blinking and stay on steady.
5.
Power up your Macintosh.
