10
M.EN 201180.01
6 Initial Steps
6.1 Setting up the equipment
6.1.1
Setting up the PEM 975
The PEM 975 is designed for permanent or
temporary mounting.
For temporary mounting, the PEM 975 can be
placed on the table, lectern, etc. We would advise
using a vibration-absorbing mat underneath (EG:
Sorbothane
®
, or similar) the microphone.
For permanent mounting the PEM 975 can be
screwed to the surface required. For hiding the
cable, a hole can be drilled in the surface before
mounting the microphone.
.
6.1.2
Setting up the N 975 power supply
1.
Install the power supply in a well-ventilated
dry place.
.
2.
Install it so that it is protected from being
knocked or dropped.
6.2 Installing the rack
The dimensions of the N 975 correspond to the 19”
rack mounting standard for mounting in a standard
rack or a built-in cupboard. The N 975 is half-width,
so it can be mounted in a half-width rack, or two can
be mounted side-by-side in a standard rack with the
supplied rack ears. If a single N 975 needs to be
mounted in a standard 19” rack, use the supplied
blanking panel in the place of the second N 975.
Place the microphone and the power supply unit
in such a way that they are protected from being
trodden on or falling down.
Ensure that the cables are not strained through
tension.
Do not use the microphone or power supply after
they have been dropped.
Repairs should only be carried out by the
Microtech Gefell GmbH Service Department.
Place the microphone and power supply unit in a
way that they are protected from being trodden on
or dropped.
Intense and/or permanent heat exposure will
destroy the microphone. Therefore, do not place
it in locations with direct sunlight or near radiators
or spotlights.
In case of an insufficient mounting depth of the
rack, there is the risk that the connectors at the
rear of the N 975 could be damaged or bent. For
this reason pay close attention to the mounting
depth and allow sufficient space for the
connectors and cables.
11
M.EN PEM2020.01