Microtec CUT4060E, Operating Manual

Page: 21 / 36

micro
Tec
   
21
5.3.1 Control
Connect the operating panel as shown on the previous pages.
If supplied, you may as well connect the following accessories:
Foot switch: Order No. H150078 (optional on request)
Inching service
Upon pushing the „Inching service“ key, the vertical object fixture will carry out a cutting
action. If the “Inching service” key is continuously pressed, the vertical object fixture will
carry out a continuous cutting action.
The speed of the vertical object fixture depends on the position of the turn switch. Range:
0-150 strokes/min.
Single stroke
By pressing the “Single stroke/foot switch” key, the vertical object fixture will carry out a
cutting stroke and a reverse stroke.
The speed of the vertical object fixture depends on the position of the turn switch.
Stop
By pressing the „Stop“ key, the microtome stops at any position.
Continuous stroke
Upon the „ Continuous stroke “ key and the „ Single stroke ” key, the vertical object fixture
will carry out a ontinuous cutting action.
For safety reasons, the continuous stroke is enabled only by pressing both keys!
Speed regulator for number of strokes
The number or strokes per minute is continuously adjustable by turning the speed
regulator for the number of strokes from the left to the right. Range of number of strokes:
0-150 strokes per min.
High Speed
By pressing the „High Speed“ key, the speed of the microtome will be increased to the
maximum speed.
LED – lights, when the motor is in operation
Speed regulator for number of strokes LED – lights, when the unit is on
Stop key High Speed key
Inching service Stoke-key = Single-stroke operation
(Important: first press Step-key and hold and then press Stroke key)