SyncServer S80 NTP User Guide
098-00777-000 Rev. A
39
show ip
Use this command to display the status and current IP settings for the Ethernet
interface.
Command Syntax:
•
To view configuration of the specified network interface:
show ip config
•
To view status of the specified network interface
show ip status
Level:
User, Config, and Admin
Example 1:
S80> show ip status
Response 1:
Link encap:Ethernet HWaddr 00:50:56:b6:66:0c
inet addr:192.168.1.100 Bcast:192.168.1.1
Mask:255.255.255.0
inet6 addr: fe80::250:56ff:feb6:660c/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:38885460 errors:0 dropped:105037 overruns:0 frame:0
TX packets:23369349 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:35465171789 (35.4 GB) TX bytes:19857282436 (19.8GB)
Example 2:
S80>show ip config
Response 2:
In IPv4 mode:
IP mode : dhcp
IP state : enable
Static mode Parameters
IP address : 192.168.1.111
IP mask : 255.255.255.0
IP gateway : 0.0.0.0
In IPv6 mode:
IP mode : dhcp
IP state : enable
Static mode Parameters
IP address : 192.168.1.111
IP mask : 255.255.255.0
IP gateway : 0.0.0.0
IPv6 mode : static
IPv6 state : enable
Static mode Parameters
IPv6 address : 2001:db8:1234::2
IPv6 prefix : 64
IPv6 gateway : 2001:db8::1
set ip
Use this command to set the address mode to DHCP (IPv4 or IPv6). Use this command to provision the
Host, Mask, and Gateway for IPv4 static addresses. Use this command to provision the Host, Prefix, and
Gateway for IPv6 static addresses..
Summary of Contents for SyncServer S80
