Microsemi PDS-104G, User Manual, Page: 18 / 48

PDS-104G PoE Switch
Power Over Ethernet PowerView Pro User Guide
Copyright © 2016 Microsemi Page 18 of 48
Rev. 1.0 CPG
– PoE BU
One Enterprise Aliso Viejo, CA 92656 USA
SNMPv3 Authentication
and Encryption Mode

None
– no authentication or encryption (no security - equivalent to SNMPv2).

MD5
– MD5 authentication with no encryption (packet can't be changed,
however it can easily be analyzed by network sniffers).

SHA
– SHA authentication with no encryption (similar to MD5, only using
different authentication algorithm).

MD5+DES
– authentication is done by MD5, while encryption is done by DES.

SHA+DES
– authentication is done by SHA, while encryption is done by DES.

MD5+AES
– authentication is done by MD5, while encryption is done by AES.

SHA + AES
– authentication is done by SHA, while encryption is done by AES.
SNMPv3 Notification (trap)
Authentication and
Encryption Mode

None
– no authentication or encryption (no security - equivalent to SNMPv2).

MD5
– MD5 authentication with no encryption (packet can't be changed,
however it can easily be analyzed by network sniffers).

SHA
– SHA authentication with no encryption (similar to MD5, only using
different authentication algorithm).

MD5+DES
– authentication is done by MD5, while encryption is done by DES.

SHA+DES
– authentication is done by SHA, while encryption is done by DES.

MD5+AES
– authentication is done by MD5, while encryption is done by AES.

SHA + AES
– authentication is done by SHA, while encryption is done by AES.
PoE MIB
– Enable
Notifications
Enable/Disable the following PoE trap reports

PoE power was provided / removed from PD device.

Unit total power consumption exceeds xy% out of max unit power.

Unit total power consumption was restored to less than xy% out of max unit
power.
PoE MIB - Notify Exceeded
Power Usage (1-99%)

Report (if enabled) whenever unit total power consumption (xy%) percentage
out of unit max power exceeds this percentage value. Also, report whenever
unit total power drops below the same percentage.
3.3.6 PoE Configuration
The user has four PoE power schemes to select from. All four power schemes comply with unit maximum
power capabilities.
Figure 11: PoE Configuration

60W
– deliver power over four pairs inside the Ethernet cable. Each pair delivers up to 30W.

30W
– deliver power over two out of four pairs inside the Ethernet cable.

15.4W
– deliver power over two out of four pairs inside the Ethernet cable.