136 Troubleshooting
_______________________________________________________________________________________________
________________________________________________________________________________________________
MICROPLEX
Operator’s Manual
SOLID F90 HD
Edition 1.0
8.2.1. Further Error Messages and Error Codes
The following printer errors will be displayed in the panel by a
hex number and a shortened error messages (or the word "ERROR").
Only a MICROPLEX authorized operator or service engineer
should address the printer problems listed in the following table.
(Exception: some errors, which are listed in the superior section 8.2, too.)
Error code
[Cut Fail.Front!
]
[E000A
]
[Cut Fail. Rear!
]
[E000B
]
[Elev.M.Err.Front! ]
[E000C
]
[Elev.M.Err.Rear!
]
[E000D
]
[Paper at Fuser!
]
[E0012
]
[Paper at Output!
]
[E0013
]
[Abnorm.PaperPos.! ]
[E0016
]
[High Volt.Fail.!
]
[E0017
]
[Drum Motor Fail.! ]
[E0018
]
[Surf.Pot.tooHigh! ]
[E0019
]
[Surf.Pot.tooLow! ]
[E001A
]
Description
Cut motor does not work normally (at the front)
Cut motor does not work normally (at the rear)
Transport motor does not work normally (no up position)
Transport motor does not work normally (no down position)
Paper does not leave the fuser unit (compare section 8.2 and 8.3).
Paper does not leave the paper exit (comp. section 8.2 and 8.3)
Position of fanfold paper is not normal
High voltage providing is not normal
Drum motor does not work normally
Surface potential is not normal (too high)
Surface potential is not normal (too low)
