Microplex SOLID F44, User Manual

Page: 116 / 167

Appendix A Programming Guide
A-23
A-5.3 Resident Barcodes Controlled by Private Command Sequences
Introduction Barcodes are programmed in three subsequent steps:
1. Select a barcode type and define the barcode specific parameter set of:
– height
– module width
– ratio of bars to spaces
– text control
2. Define barcode print position and print orientation
3. Print the barcode by sending the barcode data command
Note: For every barcode an individual set of parameters (height, module width,
ratio, and text control) can be programmed. The default values (see table on
page A-25) of these parameters are activated with the first selection of a
barcode type.
Programming a new parameter modifies only the value of the actually
selected barcode type. The value is applied until it is overwritten by a new
value or the printer is switched off. (Barcode parameters are not stored in the
printer environment!)
The Resident Barcodes are:
Code 39,
2 of 5 industrial,
2 of 5 interleaved,
EAN 8 SC2, EAN 8 SC6, EAN 8 SC9,
EAN 13 SC2, EAN 13 SC6, EAN 13 SC9,
UPC-A SC2, UPC-A SC6, UPC-A SC9,
UPC-E SC2, UPC-E SC6, UPC-E SC9,
Codabar,
MSI,
Code 93,
Postnet,
Code 128,
RM4SCC/KIX
Datamatrix Code and
USPS Intelligent Mail® Barcode IMB.