Microplex SOLID F44, User Manual

Page: 4 / 167

Safety Regulation
II
Electromagnetic Compatibility
We certify that the equipment at issue,
Type: Printer SOLID F44 and the intelligent Paper Stacker iPS F44 correspond
to the laws and regulations ruling electromagnetic compatibility of appliances
(2004/108/EC) and, therefore, fulfil the requirements for conformity marking with the
CE-sign.
To guarantee that the device stays within the limits according to the approval
regulations for conducted and radiated emission (EN 55022, Class B) and immunity
(EN 55024) in any case shielded interface cables are to be used only.
Note:
This equipment has been tested and found to comply with the limits for a
CLASS A digital device pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
Changes and modifications not explicitly allowed by the equipment's manufacturer
could void the user's authority to operate the equipment
.
Operating Environment
Avoid installing the printer where it is exposed to moisture or heat (e.g. direct
sunlight).
The printer is designed to operate in a wide range of environmental conditions.
– Temperature: + 10
°
C to + 35
°
C (+50
°
F to + 95
°
F)
– Humidity: 30% up to 85%
For best performance, store and use fanfold paper at 19
°
to 23
°
C (68
°
to 73
°
F) and
a relative humidity of 33 to 47 percent.
Note:
In case of higher values for temperature and humidity the print quality will
degrade!
Power Requirements
– 100 - 110 V (-10/+6%) AC, 12 A
– 110 - 120 V (-10/+6%) AC, 11 A
– 220 - 240 V (-10/+6%) AC, 6 A
– 50 - 60 Hz
Note:
To avoid an overload of the electric circuit support (particularly for 100 to 110
or 110 to 120V) connects the power supply plug of the printer into a
separate protected power wall socket.