Microlife OXY 210, Manual

Page: 7 / 75

5 OXY 210 EN
8. Display Mode
When the device is switched on, shortly press the ON/OFF
button
1
to switch to another display mode to select your
desired display mode 9 . There are 6 different display
modes. The default setting is mode 1.
9. Using the Lanyard
7
1. Thread the thinner end of the lanyard through the
hanging hole at the rear end of the device.
2. Thread the thicker end of the lanyard through the
threaded end before pulling it tightly.
10. Malfunctions and Actions to take
11. Cleaning and Disinfecting
Use an alcohol swab or cotton tissue moistened with
alcohol (70% Isopropyl) to clean the silicone that touches
the finger inside of the device. Also clean the finger being
tested using alcohol before and after each test. Allow the
device to dry thoroughly before use.

Never use abrasive cleaning agents, thinners or
benzene for cleaning and never immerse the
device in water or other cleaning liquids.
12. Guarantee
This device is covered by a 2 year guarantee from the date
of purchase. During this guarantee period, at our discre-
tion, Microlife will repair or replace the defective product
free of charge.
Opening or altering the device invalidates the guarantee.
The following items are excluded from the guarantee:

Transport costs and risks of transport.

Damage caused by incorrect application or non-
compliance with the instructions for use.

Damage caused by leaking batteries.

Damage caused by accident or misuse.

Packaging/storage material and instructions for use.

Regular checks and maintenance (calibration).
Descrip-
tion Symptom/Possible
causes Solutions
SpO
2
or
pulse rate
do not
display
normally.
1. Finger is not
inserted
correctly.
2. Patient SpO
2
value is too low to
be measured.
3. There is exces-
sive illumination.
1. Retry inserting the
finger.
2. & 3. Measure more
times. If you deter-
mine the product is
working correctly,
consult your doctor.
SpO
2
or
pulse rate
is shown
unstable.
1. Finger might not
be inserted deep
enough.
2. Excessive patient
movement.
1. Retry inserting the
finger.
2. Sit calmly and retry.
The
device
cannot be
powered
on. 1. No batteries or
low battery
power.
2. Batteries are not
installed
correctly.
3. The device may
be damaged.
1. Replace the
batteries.
2. Remove and rein-
stall the batteries.
3. Contact your local
Microlife-Customer
Service.
The
display
suddenly
switches
off. 1. The device is
automatically
powered off,
when no signal
was detected
after 10±2
seconds.
2. The battery
power is too low
to operate.
1. Normal.
2. Replace the
batteries.
Descrip-
tion Symptom/Possible
causes Solutions