BP3KN1-3B
19
IB BP3KN1-3B V4920 EN
EN
Problem
with Bluetooth
®
connection
If any problem occurs with the Bluetooth
®
connection, the Bluetooth
®
icon blinks rapidly
for approximately 10 seconds. To solve the
problem, please visit
www.microlife.com/connect.
* Please immediately consult your doctor, if this or any other problem occurs repeatedly.
If you think the results are unusual, please read through the information in «Section 5.»
carefully.
Other possible malfunctions and solutions
If problems occur when using the device, the following points should be checked and, if
necessary, the corresponding measures are to be taken:
Malfunction Remedy
The display remains blank when the
instrument is switched on.
1. Check batteries for correct polarity.
2. If the display is unusual, re-insert batteries or
exchange them.
The device frequently fails to measure
blood pressure values, or the values
measured are too low (too high).
1. Check the positioning of the cuff.
2. Measure blood pressure again in peace
and quiet, carefully following the details
in Section 5.
Every measurement produces a
different value.
Please read the following information listed
in Section 5.2
"Common sources of
error."
Repeat the measurement.
Please note: Blood pressure fluctuates
continually so successive measurements
will show some variability.
Allow 1-2 minutes between readings.
Blood pressure values measured at
your doctor’s office differ from your
measurements.
Record the daily development of the measured
values and consult your doctor.
Please note: Individuals visiting their
doctor frequently experience anxiety
which can result in a higher reading
than at home under resting conditions.
10. Safety, Care, Accuracy Test and Disposal
Safety and protection
Follow instructions for use. This document provides important product operation and
safety information regarding this device.