9 / 12
- ITALY - Tel. +39.035.773 925 - Fax +39.035.773 - e-mail: [email protected] - Web: www.microidea.it
PASSWORD
The password, once enabled, must be inserted each time the parameters are saved and, in
Manual
mode, also
to authorize the changeover.
As default, the password is disabled but here is the procedure to enable it:
1) Inside the
“IMPOSTAZIONI”
select on
P0C “PASSWORD”
(default OFF) then press key
(SET)
.
2) Press key
to set the value to
ON
, then press
(SET)
to confirm and access the
“PASSWORD”
screen
where you will be asked to insert the actual password, if this is the first time leave the value default
“0000”
.
3) Press key
(SET)
to confirm and to go to the new password insertion.
4) Use key
and
to define a number from 0 to 9, then
(>)
to select the next digit.
Repeat the procedure for the 4 digits.
5) Press key
(SET)
to confirm and go back to parameters selection, then
(EXIT)
for
3s
to exit and return
to the home screen.
6) At the prompt
“Save parameters?”
press key
(YES)
to confirm or
(NO)
to cancel.
1)
2)
3)
4)
5)
6)
