© Microhard Systems Inc.
48
4.0 Configuration
If the pX2 is integrated into a network which has a defined gateway,
then, as with other hosts on the network, this gateway’s IP address will
be entered into this field. If there is a DHCP server on the network,
and the Connection Type (see previous page) is selected to be DHCP,
the DHCP server will populate this field with the appropriate gateway
address.
Default Gateway
Values (IP Address)
(no default)
DNS (Domain Name Service) Servers are used to resolve domain
names into IP addresses. If set to auto and the Connection Type is set
for DHCP the DHCP server will populate this field and the value set
can be viewed on the Network > Status page. To add additional static
servers, enter them here.
Primary DNS
Values (IP Address)
(no default)
The Default Route parameter allows you to set this interface as the
default route in the routing table. This is result in all data being sent to
the WAN interface if there the destination network is not directly
connected (LAN, WIFI etc), and no other route has been specified. In
cases where the WAN is the primary connection this would be set to
Yes.
Default Route
Values (selection)
No
/ Yes
DNS Servers
The following section will allow a user to specify DNS Server(s) to be used by the WAN interface of the
pX2.
Select between Manual or Auto for DNS server(s) for the WAN
interface. If set to Auto the pX2 will try to automatically detect the DNS
servers to use, which is normally the case when the WAN is DHCP.
Manual required the DNS addresses to be known and entered below.
Mode
Values (selection)
Manual /
Auto
DNS (Domain Name Service) Servers are used to resolve domain
names into IP addresses. If set to auto and the Connection Type is set
for DHCP the DHCP server will populate this field and the value set
can be viewed on the Network > Status page. To add additional static
servers, enter them here.
Secondary DNS
Values (IP Address)
(no default)
