© Microhard Systems Inc.
58
4.0 Configuration
The BulletPlus supports one or two SIM cards to be installed. By
default the primary SIM is the top SIM, and the unit will try to connect
using SIM1 first, and then if it fails to connect, or loses connection to a
valid carrier, it will then attempt SIM2.
SIM Selection
Values (Selection)
Dual SIM Cards
SIM Card-1 Only
SIM Card-2 Only
Dual Cards Management
By default the Primary SIM is the SIM installed into the SIM1 slot on
the unit. The SIM card installed into the Primary slot will be the Cellular
Carrier in which the BulletPlus will attempt to make a connection with.
This can be modified here.
Primary Slot
Values (Selection)
SIM Card-1
SIM Card-2
IP pass-through allows the WAN IP address to be assigned to the
device connected to the LAN or WAN ports. In this mode the Bullet is
for the most part transparent and forwards all traffic to the device
connected to the selected Ethernet port except that listed below:
The WebUI port (
Default Port:TCP 80
), this port is retained for remote
management of the Bullet. This port can be changed to a different port under
the
System > Services
Menu.
The SNMP Listening Port (
Default Port: UDP 161
).
Port Forwarding Rules. The BulletPlus forward to other internal modem
services (Iperf etc) by using X.X.X.1 for an internal IP Address.
The virtual IP address is configurable to allow access to the unit on the
LAN/WAN connector once IP-Passthrough has been enabled.
The firewall/rules must be configured to allow traffic, all incoming
carrier traffic is blocked by default.
IP-Passthrough
Values (Selection)
Disable
Ethernet (LAN)
WAN
SIM Card-1 Settings
This feature allows the disabling or enable of data roaming. When data
roaming is enabled the modem will be allowed to use data when in
roaming status. It is not recommended to allow roaming unless the
appropriate data plans are in place.
Data Roaming
Values (Selection)
Enable /
Disable