3
- Please do not attempt to open unit. It is only to be serviced by an authorized technician. If this occurs, or is apparent, the
warranty will be voided.
- The fixture’s warranty will be voided if there are any malfunctions from not following the user manual or any illegal
operation (shock short circuit, electronic shock, lamp broke, etc.)
- The Titan RGB 1.5 has a feature where you can track the overall usage of the fixture (fixture hours)
MASTER/SLAVE MODE
-
To run the TITAN RGB 1.5 in master/slave mode, the unit must be set to either “AUTO” or “SOUND ACTIVE” mode.
The unit must be linked with 3pin XLR to the next fixture. All SLAVE units must be set to “SLAV” through the on
board menu. Once selected, press ENTER to confirm.
AUTO-RUN MODE
-
To run the TITAN RGB 1.5 in AUTO mode, you must set the unit to “AUTO-PLAY” using the on board menu. Once
selected, press ENTER to confirm.
SOUND ACTIVE MODE
-
To run the TITAN RGB 1.5 in sound active mode, you must set the unit to “AUDI” using the on board menu. Once
selected, press ENTER to confirm.
DMX MODE
-
To control the TITAN RGB 1.5 via DMX, select “dxxx” on the display. By using the UP and DOWN buttons select
your desired DMX address and press ENTER to confirm. The TITAN RGB has a total 12 channels of DMX.
ILDA (PC CONTROL) MODE
-
To run the TITAN RGB 1.5 in IDLA mode or (PC CONTROL MODE) simply connect your ILDA signal cable to the DB25
jack located on the rear of the unit, and the unit will automatically recognize. NOTE: when ILDA is connected, it
supersedes all modes.
4. MOUNTING AND INSTALLATION
Caution:
For added protection, mount the fixtures in areas outside walking paths, seating areas, or in areas were the fixture might
be reached by unauthorized personnel. Before mounting the fixture to any surface, make sure that the installation area can hold a
minimum point load of 10 times the device’s weight. Fixture installation must always be secured with a secondary safety attachment,
such as an appropriate safety cable. Never stand directly below the device when mounting, removing, or servicing the fixture.
Whether installing inverted on a truss or ceiling, or set on a flat level surface (see illustration below). Be sure this fixture is kept at
least 0.5m (1.5 ft) away from any flammable materials (decoration etc.). Always use and install the supplied safety cable as a safety
measure to prevent accidental damage and/or injury in the event the clamp fails.
Mounting Points:
Overhead mounting requires extensive experience, including calculating working load limits. A knowledge of the
installation material being used, and periodic safety inspection of all installation material and the fixture are all imperative and should
only be performed by a qualified technician. Improper installation can result in bodily injury and damage.
Be sure to complete all rigging and installation procedures before connecting the main power cord to the appropriate wall outlet.
