14
11. MAINTENANCE AND CLEANING
The following points have to be considered during the inspection:
1) All screws for installing the device, or parts of the device must be tightly connected, and must not be corroded.
2) There must not be any deformations on the housing, colour lenses, fixations or installation spots (ceiling, suspension,
trussing).
3
)
Mechanically moved parts must not show any traces of wearing and must not rotate with unbalances.
4
）
The electric power supply cables must not show any damage, material fatigue or sediments.
Further instructions depending on the installation spot and usage must be handled by a skilled installer or technician. Any
safety issues must be resolved.
In order to keep the fixture in good condition and extend the life, we suggest regular cleaning to the fixture.
1) Clean the inside and outside lens each week to avoid the light output from darkening due to accumulation of dust,
dirt, etc.
2) Clean the fan each week.
3) A detailed electrical check by approved technician every three months is advised. Ensure the circuit contacts are
in good condition, and prevent from overheating.
We recommend a frequent cleaning of the device. Please use a moist, lint- free cloth. Never use alcohol or solvents.
There are no serviceable parts inside the device. Please refer to the instructions under “Installation instructions”.
Should you need any spare parts, please order genuine MICROH parts from your local dealer.
IF YOU SHOULD EXPERIENCE ANY PROBLEMS OR ISSUES PLEASE CONTACT MICROH PROFESSIONAL
PRODUCTS BY EMAIL AT
In the event that your unit is defective in any way, please contact your local dealer to obtain an RA number for
service repair.
DISCLAIMER – MICROH believes that the information contained within this user manual is accurate. However,
Microh is not responsible for any error or addendums to this manual. If you have any comments or general
suggestions on how this manual can be improved please contact
. Thank you
