Operation Instructions
•
Do not turn this fixture on if it has been through severe temperature differences.
Damage may occur to the fixture. Wait until unit is at room temperature to operate.
•
This unit should be protected from any tremors or agitations during transport.
•
Do not expose the fixture to any excessive heat, moisture or any environment
with a lot of dust while installing. Do not lay any power cables on the floor. It
may cause electric shock or damage to persons or equipment.
•
Make sure to attach the safety chain and ensure the screws are properly
screwed in when installing the fixture.
•
Make sure the fixture is operated and installed by qualified personnel.
•
Keep the original packaging in case of defective product.
•
Any non-manufacturer additions, modifications or changes in any way will void
warranty of this product.
•
Please do not attempt to open this unit. It is only to be serviced by an authorized
technician. If this occurs, or is apparent, the warranty will be voided.
•
This fixture’s warranty will be voided if there are any malfunctions from not
following the user manual or any illegal operation (shock, short circuit, electric
shock, lamp break, etc.).
•
This fixture is equipped with six operating modes (Master/Slave, DMX, Sound
Active, Manual Mode, Colour Fade, and Colour Chase).
Master/Slave
Mode
•
By connecting either the 3 or 5 pin DMX,you can daisy chain up to 30 units on
one Master/Slave model. Daisy chain the fixtures together by plugging from
the DMX output of the first fixture into the DMX input of the second fixture, and
so on...
•
On your master fixture, set the unit to Sound, Manual, Colour fade, or Colour
chase control and select one of the internal programs.
•
All slave lights must be set “A001”
DMX
•
From the main menu select “ADDR” and press ENTER. By using the UP and
DOWN buttons, you can set the DMX address. Press ENTER when number
is reached.
•
Once the address is set, leave the unit powered on for three minutes in order
to store the address within the unit so that it returns to the unit returns to that
address when its powered on/off.
•
To select between one of the three DMX modes, select “ADDR” and press
ENTER. Press ENTER again and choose either “Axx”, “Fxxx”, or “Pxxx” with
UP and DOWN arrows.
