Microframe Corporation
Series 3500 - MultiPage System
13
3.332 Auto Delete Setting
The Display can be set to automatically
delete a number from its memory after a
preset time.
NOTE: If you have a MultiPage
Transmitter, use the Transmitter's auto delete
rather than the Display's auto delete time.
To
set the auto delete time send a page to
Pager
9999 with the message “02_XX” where XX is a
number from 1 to 42 representing the number
of minutes to wait before auto deleting.
3.333 Chime Setting
If you have purchased an optional triac
circuit, it can be activated every time a new
number is sent to the Display. The duration of
the triac output can be controlled by changing
this option. To change this option, send a page
to 9999 with the message “03_XX” where XX is a
number from 00 to 99 representing the number
of 0.1 second intervals that you want the output
to be on (i.e. 99=9.9 seconds). Sending a 00 will
cause the triac circuit to be disabled.
3.334 Clear All Numbers Command
There are occasions where you may want
to clear all numbers from all Displays. To clear
all numbers, send a page to Pager 9999 with
the message “99_98.”
3.335 Reset Factory Defaults
To change the Display settings back to fac-
tory defaults send a page to Pager 9999 with
the message “99_99.”
3.336 Using the UHF Display With A
DataPage Lite or DataPage II
The Wireless UHF Display has been de-
signed to work optimally with the MultiPage
software developed by Microframe Corporation.
However, in rare cases you may want to use
the Display with a Transmitter other than the
MultiPage. If so, you can control the Display's
basic functions by sending pages to the Display’s
address with beep types and messages to control
the function. Beep type “4” enters the number
contained in the message into the Display. Beep
Type “3” removes the number contained in the
message from the Display.
3 WIRELESS UHF DISPLAY