2
CONTENTS
Figure 1: New Microdrones vehicle
4. Repeat steps above for each your Microdrones vehicle.
Note that if both uplink and downlink are connected only uplink will be active because the Microdrones stops
telemetry sending after reception of commands via uplink. The downlink can be activated either by issuing "A-
RM" command or by disconnecting uplink and re-inserting a battery.
1.2
Mission execution specifics
Home location cannot be modified by UgCS. It is controlled by the autopilot and is permanently bound to a take-off
position.
1.3
Command execution specifics
Command
Support
Notes
ARM
Partial
The command issuing does not
turn on motors but allows doing it
from RC without battery
re-inserting. It also activates
telemetry sending.
DISARM
Partial
Does not stop motors but activates
uplink channel and deactivates
telemetry sending.
AUTOMODE
No
MANUALMODE
No
CLICK & GO
No
JOYSTICK
No
HOLD
No
CONTINUE
No
Copyright © 2017, SPH Engineering
