Microcom 324M, Operator'S Manual

Page: 224 / 234

324M/424M Operator’s Manual - 880026-0144 13-17
^A ^D COMMAND
xxyy 135 Save FONTS to FLASH: This command is used to save font’s into the
printer’s non-volatile flash memory. The ^Axxyy^D135 command is placed at
the beginning of a font file download and instructs the printer to save the
following data as a font file. The <ESC> (^[ or 0x1B) instructs the printer the
end of file download and acts as the command terminator.
xx The number of additional 64KB sectors needed to save the graphic file.
yy The memory slot location of the graphic being saved; CGN # (1-255)
XX 136 Delete a FONT from RAM: Instructs the printer to delete a graphics from
RAM. Issuing a “0” for the ^A value causing the printer to delete all RAM
fonts. The ^A value is used to select the memory slot or CGN # that will be
deleted. The valid values for Axx are 0 to 255.
XX
137 Delete a FONT from FLASH: Instructs the to delete a font stored in flash
memory. Issuing a “0” for the ^A value causing the printer to delete all flash
fonts. The ^A value is used to select the memory slot or CGN # that will be
deleted. The valid values for Axx are 0 to 255.
XX
138 Process a FLASH FORMAT: This commands instructs the printer to process
or run a saved format from flash memory as if it was sent to the printer.
XX 139 Send a FLASH FORMAT to the Communication Port: This command
instructs the printer to send the contents of a stored format to the printer’s
active communications port without processing the stored format.
140 Clear all User FLASH: Instructs the printer to delete all fonts and graphics
stored in non-volatile flash memory. Format files stored in flash are not
deleted by this command. This command is equivalent to sending a
^A0^D134 and a ^A0^D137 to the printer.
141 Clear User FLASH & RAM memory: This command instructs the printer to
delete all fonts and graphics stored in both RAM and flash memory. This
command is the equivalent to sending the ^D100 and ^A0^D140 commands to
the printer.
1 143 Save and Reboot Printer: This command instructs the printer to save
statistics stored in RAM to non-volatile Flash memory and then actually resets
the printer hardware. Issuing this command is the equivalent of turning the
printer off and back on. This command may be used to start using certain
non-volatile system parameters (head parameter and soft switch commands).
It is recommended that this command is sent before updating the printer’s
software to ensure that the printer’s configuration and statistics are saved
before the update starts.
145 List Commands: This command is used to generate a list of commands
containing a brief description of the LDSI code base that the printer uses.
Issuing a ^D145 or ^A0^D145 causes the printer to generate a list of
commands supported by the LDSI code base to communications port.