micro-trak Calc-An-Acre II, Reference Manual

Page: 19 / 30

19
The AREA, DISTANCE, TOTAL HOURS and SUB HOURS
counters maintain a running count during operation
regardless of the position of the rotary switch. When any of
these counters reach their maximum capacity, or when you
want to start a new count, the value may be reset to zero
by performing the following routine. Counters may be reset
independently of each other.
1. Put the system in HOLD.
2. Turn the rotary switch to the counter to be reset.
3. To reset distance, total hours and sub hours, turn the
rotary switch to the desired function and simply press
and hold the RESET button until the display reads
zero. The display will show the word “CLEAr” during
this process, and will show 0.0 when reset to zero is
complete.
4. To reset the area counters; there are three independent
AREA counters. The active counter is indicated by
the small numbers in the lower right area of the
display (1,2, or 3) when the rotary switch is in the
AREA position. Select the counter you want to use
by pressing the “+” button. The small number will
increment each time the “+” button is pressed (from
1 to 3, then rolls back to 1). DO NOT attempt to select
the counter number by using the “-” button, because
that will clear the active counter if held for 2 seconds. If
the “-” button is accidentally pressed, the console will
display “CLEAr” to alert the user that the counter will
be cleared. If the user continues to hold the “-” button
for 2 seconds “CLEAr” will disappear and be replaced
by 0.0, indicating that the selected counter has been
cleared.
To select an AREA counter: Verify that the desired counter is
selected, or use the “+” button to select.
SHAFT
CAL
SPEED
CAL
WIDTH
CAL
SUB HOURS
DISTANCE
AREA /
HOUR
TOTAL HOURS
SPEED
AREA
(1) (2) (3)
CAL
RUN
HOLD
RESET
WIDTH +/-
®
II
RPM
UNITS
CALHOLD
1 2 3 4 5
Display indicates
that counter #1
is selected
SHAFT
CAL
SPEED
CAL
WIDTH
CAL
SUB HOURS
DISTANCE
AREA /
HOUR
TOTAL HOURS
SPEED
AREA
(1) (2) (3)
CAL
RUN
HOLD
RESET
WIDTH +/-
®
II
RPM
UNITS
MAN HOLD
1
SHAFT
CAL
SPEED
CAL
WIDTH
CAL
VOLUME /
MINUTE
DISTANCE
AREA /
HOUR
RATE SPEED
AREA
(1) (2) (3)
CAL
RUN
HOLD
RESET
TANK
®
II
RPM
UNITS
MAN HOLD
CALHOLD
2
Display indicates
that counter #2
is selected
SHAFT
CAL
SPEED
CAL
WIDTH
CAL
SUB HOURS
DISTANCE
AREA /
HOUR
TOTAL HOURS
SPEED
AREA
(1) (2) (3)
CAL
RUN
HOLD
RESET
WIDTH +/-
®
II
RPM
UNITS
MAN HOLD
3
Display indicates
that counter #3
is selected
Operation
Resetting System Counters