20
Troubleshooting
Messages/Warnings
This message appears when an error occurs while verifying calibration values during the
power-up. Enter calibration and verify that the calibration values have not changed and exit
calibration. Cycling power will not clear the bad CAL message. The message can only be
cleared by entering and exiting calibration mode.
Low Power. Check all power and ground connections.
Shows when Default Cal factors are saved in memory. This function takes place if CAL and “-”
buttons are pressed and held down for more than 3 seconds when loading Defaul Cal factors.
Has loaded Default Cal factors (appears when default calibration factors are loaded by
holding CAL and “-” buttons while turning the console on).
On startup, the “V” is displayed next to the software version #. (Console hours displayed first.)
The message alerts the user that the currently selected counter will be cleared if held for
2 seconds. Also serves as a reminder to use “+” button to select AREA counters.
Counters (DISTANCE, AREA, TOTAL HOURS or SUB HOURS) have overflowed their maximum.
RESET (see page 20) to clear counters and resume counting.
Summary of Contents for Calc-An-Acre II
Page 1: ......
Page 24: ...24 Appendices ...
