Page 45
thermoMETER TIM 8 / thermoIMAGER TIM 40
Hot-/Coldspot Function in Autonomous Operation
The setting for a hot- or coldspot in autonomous mode differs from the general procedure. It is not enough to
mark a measuring area as hot- or coldspot. Instead, a
User defined rectangle
must be selected under
the tab
measure areas
of the configuration dialog. In addition, under
Mode
, you must set whether the
maximum
(for hotspot) or
minimum
(for coldspot) should be output.
Fig. 25 Setting a hotspot for autonomous operation
For a hot- or coldspot output in the full field of view of the camera, the user defined rectangle must also fill out
this size.
Fig. 26 Measure area over entire field of view