Page 56
Liability for Material Defects
scanCONTROL 30xx
9.
Liability for Material Defects
All components of the device have been checked and tested for functionality at the factory. However, if defects occur despite our care-
ful quality control, MICRO-EPSILON or your dealer must be notified immediately.
The liability for material defects is 12 months from delivery. Within this period, defective parts, except for wearing parts, will be repaired
or replaced free of charge, if the device is returned to MICRO-EPSILON with shipping costs prepaid. Any damage that is caused by
improper handling, the use of force or by repairs or modifications by third parties is not covered by the liability for material defects.
Repairs are carried out exclusively by MICRO-EPSILON.
Further claims can not be made. Claims arising from the purchase contract remain unaffected. In particular, MICRO-EPSILON shall
not be liable for any consequential, special, indirect or incidental damage. In the interest of further development, MICRO-EPSILON
reserves the right to make design changes without notification.
For translations into other languages, the German version shall prevail.
10.
Service, Repair
If the sensor or sensor cable is defective:
- If possible, save the current sensor settings in a parameter set, see
Configuration Tools, menu
Parameters > Save para-
meters to file...
, in order to load the settings back again
into the sensor after the repair.
- Please send us the effected parts for repair or exchange.
If the cause of a fault cannot be clearly identified, please send the
entire measuring system to:
MICRO-EPSILON Optronic GmbH
Lessingstraße 14
01465 Dresden - Langebrück / Germany
Tel. +49 (0) 35201 / 729-0
Fax +49 (0) 35201 / 729-90
e-mail: [email protected]
www.micro-epsilon.com
11.
Decommissioning, Disposal
Remove all cables between the scanCONTROL 30xx sensor and the following control or evaluation units.
Incorrect disposal may cause harm to the environment.
Dispose of the device, its components and accessories, as well as the packaging materials in compliance with the applicable
country-specific waste treatment and disposal regulations of the region of use.
Summary of Contents for LLT3000-100
Page 6: ...scanCONTROL 30xx...
