Page 7
Installation of IF2008/PCIe
IF2008/PCIe / IF2008E
Sensor interface (X1)
- Identical to IF2008/PCIe (X1)
I/O-Interface (X2)
- 4x Optocoupler inputs, input current max. 5 mA,
input frequency max. 1 Mhz
- 4x Optocoupler outputs, output current max. 20 mA,
output frequency max. 1 Mhz
5.
Installation of IF2008/PCIe
For installing the IF2008/PCIe please proceed as follows:
Switch off your computer as well as all peripheral devices. Unplug
the power cords.
Open the housing of your computer. For further details please find
the instruction in your computer manual.
Find a PCI extension slot for the IF2008/PCIe card which is not as-
signed. Remove the cover of the slot, keep hold of the card on the
top edge while carefully pushing it into the slot. The card must be
fastened to the mounting using bolts.
i
IF2008/PCIe requires on X7 an external supply voltage through
PC!
Connect X7 of the IF2008/PCIe with the power supply of the PC.
Therewith you support the necessary power supply of the DC-/DC
converter.
The IF2008E has to be fastened to a mounting which is not as-
signed using bolts. Interconnect the interface cards IF2008/PCIe
and IF2008E. Connect the plug connectors of the same numbering
using the cables which are included in delivery, that means X4 with
X4, X5 with X5, X6 with X6.
Close the housing of your computer and switch
on the computer as well as the peripheral de-
vices.
Analog interface (X3)
- 2x ADC channels
- Input voltage range 0-5 V, 0-10 V, ±5 V, ±10 V, sepa-
rately adjustable for each channel via DIP switch
- Resolution 16 bits
- Offset error max. ±3 mV
- Gain error max. ±5 mV
- Conversion rate max. 150 kHz per channel
X7
Power
supply
PC
IF2008/PCIe
IF2008E
