Page 8
Safety
thermoMETER CSmicro
Do not kink the sensor cable and bend the sensor cable in tight radius. The minimum bending radius is
14 mm (static). A dynamic movement is not allowed.
> Damage to the sensor cable, failure of the measuring device
No solvent-based cleaning agents may have an effect on the sensor (neither for the optics nor the housing)
> Damage to or destruction of the sensor
Avoid static electricity and keep away from very strong EMF (electromagnetic fields) e.g. arc welders or
induction heaters.
> Damage to or destruction of the sensor
Avoid changes of the operating temperature.
> Inaccurate measuring values
If sensors of the type CS / CSmi / CSmi2W und CsmiHS are connected to a USB-programmer TM-USBK-CS,
please ensure that the used CompactConnect Software has got a version 1.8.7 or higher.
> Version below 1.8.7 will destroy the sensor after the first write attempt!
1.3
Notes on CE Identification
The following applies to the thermoMETER CSmicro:
- EU-Directive 2014/30/EU
- EU-Directive 2011/65/EU, „RoHS”, category 9
Products which carry the CE mark satisfy the requirements of the quoted EU directives and the European
standards (EN) listed therein. The EC declaration of conformity is kept available according to EC regulation,
article 10 by the authorities responsible at
MICRO-EPSILON MESSTECHNIK
GmbH & Co. KG
Königbacher Straße 15
94496 Ortenburg / Germany
The system is designed for use in industry and laboratory and satisfies the requirements.
