Michell Instruments QMA601, User Manual

Page: 64 / 112

QMA601 User’s Manual
54 97449 Issue 3, June 2018
MAINTENANCE
4 MAINTENANCE
The power to the enclosure must be turned off before any
work is carried out in the measurement system enclosure.
Before commencement of the start-up procedure ensure
thatall power and signal connections to the QMA601 are
fully isolated and if necessary observe the stipulated de-
energization
period of 45 minutes.
!
Gas line connections to the measurement system must be
isolated and de-pressurized before any work commences.
Any loose or disturbed tubework or couplings must be leak
tested.
The design of the QMA601 and measurement system is such that no specific routine
maintenance is required. However, if a fault does occur with the system that is not
covered within this manual please contact Michell Instruments (see contact information
at www.michell.com) or your local representative.
The QMA601 is a certificated product for use in Zone 1 Hazardous Areas. Any
maintenance of this product should only be conducted by suitably trained personnel
and in accordance with locally applying regulations. Any unauthorized maintenance of
this product could invalidate the product warranty.
In addition to general maintenance procedures which involve the cleaning of the
analyzer’s casing and display, there are a number of parts in the QMA601 which can be
removed and replaced by the operator.
They are as follows:
• Power supply fuse (see Section 4.2)
• Optional contamination trap (see Section 4.3)
• Desiccant column (see Section 4.4)