Michelin 2190170, Instruction Manual

Page: 4 / 17

-9- -7- -8-
When in CLOCK mode, hold Button A for 3 seconds in order
to reset the clock.
Press Button B to select, 12/24 hour format, hour and minute
and press Button A to confirm.
Press Button B to switch to another mode.
Press Button A to enter the sub-menu of this mode.
Holding Button A will reset the mode or go to the setting mode
of the sub-menu.
CLOCK: Holding Button A for 3 seconds
will put the computer into clock setting
mode.
Holding Button A for 3 seconds will go to the
computer setting mode of wheel size and
odometer save function for bikes 1 and 2.
ODOMETER SAVE FUNCTION
The odometer save function allows you to re-input the key data
of total distance covered even after replacing the battery . Press
Button B to adjust and press Button A to confirm the setting.
Holding Button A for 3 seconds will
take you to the service program
setting for bikes 1 and 2.
TRIP DISTANCE (DST):
Trip information reset: Holding Button A for 5
seconds will reset the trip distance, trip meter
and average speed.
MAXIMUM SPEED (MXD)
Hold Button A for 5 seconds to clear the
maximum speed.
AVERAGE SPEED (AVS)
The average speed will be reset by the Trip
information reset function in the Trip distance
mode.
TRIP TIME (TM):
The trip timer will be reset by the Trip
information reset function in the Trip distance
mode.
TEMPERATURE:
Degree C or degree F selection:
Holding Button A for 3 seconds will enter the
degree C/F selection.
Press button B to select and then press
Button A to confirm.
FAT BURN (F):
Holding Button A for 3 seconds will reset the
fat burnt in grams.
CALORIES (CAL):
Holding Button A for 3 seconds will reset the
Calories data.
SCAN:
The trip distance, maximum speed, average
speed and trip timer will be automatically
displayed every 4 seconds.
12. SELECTION OF BIKE 1 & BIKE 2
        

 
   



      
      
13. COMPUTER RESET

           

 
           


        
          
           
     
14. STARTING THE COMPUTER
          
           
       
15. AUTO SLEEP
             
          
        
The temperature displayed is the internal temperature of the
device and therefore can be by direct sunlight.
To display the real temperature, the computer should be in shade
for about 3 minutes.
MALFUNCTION & PROBLEM
Unknown atmospheric or Radio
Frequency interference
Incorrect magnet/transmitter
alignment check battery and correct
installation if necessary
Temperature too hot, or display
exposed to direct sunlight too long
Check correct sensor/ magnet
allignment
Check battery and correct installation
Take out computer battery and install
again