Copyright © 2009-2011 Micca, Ltd. All rights reserved.
VI. Connecting the Micca MPLAY
A. Power
Only use the supplied AC power adapter to provide 5.0VDC power to the Micca
MPLAY. Using a different power adapter may damage the player. Do not cut off
power to the device while the unit is turned on as this may cause serious damage
to attached storage devices and result in data loss.
The MPLAY has a master power switch on the back. During normal use, set this
switch to on and use the remote to turn the MPLAY on or put it into standby
mode. Set this switch to off if not planning to use the MPLAY for a long time to
conserve power. Make sure that the player is in standby mode before
disconnecting power.
B. AV Output
The Micca MPLAY can be connected to analog TVs through its AV Out
connector. Only use the supplied 3.5mm-to-RCA AV cable to ensure correct
signal polarity and avoid damage to the player and TV/display.
The RCA cable connectors are color coded to match the AV input on TVs and
display devices as follows:
Red
Right Audio Channel
White
Left Audio Channel
Yellow
Composite Video
The Micca MPLAY must be set to NTSC or PAL Composite mode for the analog
AV output to function. If there is no picture displayed after connecting the AV
Output and turning on the Micca MPLAY, press the <Setup> button on the
remote and then press the <TV Mode> button to switch between output modes
until the correct mode has been selected. There will be a short delay when
