7. Use the included zip ties to ensure that the DLS2 cable is routed neatly and secured to
the gimbal connectors at the bottom of the drone. A cutting tool should be used in
order to cut off excess plastic from the zip ties. Be sure that the cable and zip ties are
not blocking any cameras or sensors surrounding the drone.
The finished assembly should look similar to Fig. 1 below.
Warning: Before any flight, always be sure to check the DLS2 and any other
mounted components are secure. Screws and cable ties can loosen over time
due to wind and vibration during flights. The included Loctite threadlocker helps
to avoid this, but it is not foolproof. Always do a pre-flight safety check!
Fig. 1: DLS 2 mounted on M300 RTK
Note: your rubber dampers may vary
Rev 01 - July 2020
PAGE 4
