6
Mi-T-M
®
HSE-SERIES Operator's Manual
RISK OF BURNS
RISK FROM MOVING PARTS
Serious injury may occur from
touching the heat exchanger. This
area can remain hot for some time
after the pressure washer is
shutdown.
Serious injury may occur from a
pressure washer malfunction or
exploding accessories if incorrect
system components, attachments or
accessories are used.
Serious injury or death may occur if
attempting to start the pressure
washer when the pump is frozen.
Serious injury may occur to the
operator from moving parts on the
pressure washer.
Never make adjustments to the factory set pressures.
Never exceed manufacturers maximum allowable
pressure rating of attachments.
Do not allow any hoses to make contact with heat
exchanger to prevent the possibility of bursting.
Avoid dragging the hoses over abrasive surfaces
such as cement.
Use only manufacturer recommended repair parts
for your pressure washer.
In freezing temperatures, the unit must always be
warm enough to ensure there is no ice formation in
the pump. Do not start the pressure washer if it has
been transported in an open or underheated vehicle
without first allowing the pump to thaw.
RISK OF BURSTING
Do not operate the unit without all protective
covers in place.
Follow the maintenance instructions specified in
the manual.
Never make adjustments to the unit while it is
connected to the power source.
Never allow any part of your body to contact the heat
exchanger.
Do not leave unit unattended after shutdown until it
is completely cooled down as described in the
"SHUTDOWN" procedures listed on page 20 of this
manual.
HAZARD
POTENTIAL CONSEQUENCE
PREVENTION
IMPORTANT SAFETY INSTRUCTIONS
READ ALL SAFETY WARNINGS BEFORE USING PRESSURE WASHER
Serious injury or death could occur
from high pressure spray penetrating
the skin.
Keep clear of nozzle and spray! Never put your
hand, fingers or body directly over the spray nozzle.
Never point the high pressure discharge spray at
yourself or anyone else.
This product is to be used only by trained operators.
Always keep operating area clear of all persons.
DO NOT allow children to operate this unit.
SEEK EMERGENCY MEDICAL CARE if the spray
appears to have penetrated the skin! DO NOT
TREAT AS A SIMPLE CUT!!
High pressure hoses and fuel lines should be
inspected daily for signs of wear. If evidence of
failure exists, promptly replace all suspect hoses
and fuel lines to prevent the possibility of injury from
the high pressure spray. If a hose or fitting is leaking,
NEVER PLACE YOUR HAND DIRECTLY ON THE
LEAK.
NEVER operate the gun with the trigger wired in the
open position. To prevent accidental discharge, the
trigger gun should be securely locked when not in
use.
Before removing the spray nozzle or servicing the
unit, ALWAYS shut off the unit and trigger the gun to
release trapped pressure. (Even after you shut off
the unit, there is high pressure water left in the pump,
hose and gun until you release it by triggering the
gun.)
RISK OF INJECTION
OR
SEVERE CUTTING INJURY
