13
70D0004
TPB Series Log Set
VENTED APPLIANCE INSTALLATION
PLACE AND SECURE APPLIANCE
W
ARNING
You must secure the gas log heater to
the fireplace floor. If not, the entire unit
may move when you adjust the controls.
Movement of unit may cause shifting of
the gas logs which leads to sooting and
improper burning. Grate movement could
cause a gas leak.
Special care is required if you are installing
the unit into a sunken fireplace. You must
raise the fireplace floor to allow access to
gas log controls. This will insure adequate
air flow and guard against sooting. Raise
the fireplace floor using noncombustible
materials, as described in Placement in a
Fireplace with Restrictive Barrier on Page
7.
ASSEMBLY PROCEDURE:
1. Center the gas log unit on the fireplace or firebox. Make
certain the front of the burner sits inside the front edge
of the fireplace or firebox.
. Anchor holes are located on the right and left sides of
the unit. After centering the burner correctly, mark the
hole positions on the fireplace/firebox floor. Drill two ()
5/3" diameter holes approximately 1
Z\x
" deep.
3. Anchor the burner to the fireplace/firebox floor using
the screws provided.
Figure 14
Proper installation of the grate is essential to prevent
any movement of the gas logs and controls during
operation.
FP2866
Secure heater
Screw
Screw
Anchor Hole
Figure 14 -
Secure Heater to Floor to Fireplace/Firebox
FP866