MHS Boilers CRUZ belt, Installation, Operation & Maintenance Manual, Page: 18 / 46

CRUZbelt
18
E0032544Rev090710
MAINTENANCE SCHEDULE
Maintenance intervals will vary site by site.
Establish short intervals at first, then lengthen if
possible. The following is based on 8 hours per day,
5 days per week under normal conditions:
DAILY
•
Listen for unusual noises
•
Inspect conveyor for debris
•
Check belting for build up or debris
•
Verify all pulleys and rollers turn free
•
Verify all guarding is in place
•
Check for oil leakage
•
Check for unusual vibration
•
Check for loose bolts or parts
WEEKLY
•
Inspect belt for proper tracking and tension
•
Inspect belt lacing
•
Inspect belt edges for fraying
•
Inspect bearings and gear motor for
excessive heat or noise
•
Clean breather vent on gear motor
•
Check operation of all electrical controls
•
Inspect motor mounting bolts
MONTHLY
•
Clean chains and sprockets. Lubricate with
synthetic 30 weight oil.
•
Check chain tension and alignment
•
Clean belt with compressed air or stiff brush
•
Check gear motor oil level
•
Check pulley lagging for signs of wear
SEMI-YEARLY
•
Clean belt and all surfaces with detergent
and water
•
Grease drive pulley and power take-off
bearings.
YEARLY
•
Inspect bolts for tightness
•
Check for plumb and level.
•
Touch up paint
TWO YEARS OR 10,000 HOURS
•
Drain and fill gearmotor with ISO VG220
mineral based oil.
CAUTION
Verify all tools and foreign objects have been
removed from conveyor. Check that all guards have
been replaced and bolts have been retightened.