MHS Boilers CRUZ belt, Installation, Operation & Maintenance Manual, Page: 14 / 46

CRUZbelt
14
E0032544Rev090710
BELT TRACKING
WARNING
Only qualified personnel should be allowed to track
the belt. Use caution since conveyor must be run
during the tracking procedure.
ALL PULLEYS AND SNUBBERS MUST BE
SQUARE
and conveyor must be level prior to
tracking the belt. Align the 3/8” square in the cam
and snubber bracket with the corresponding square
in the bed frame. (See “Conveyor Set-up” section).
Conveyor must be wired to run the correct direction.
Belt should be tensioned tight enough to drive the
heaviest product.
Belt tracking is accomplished using either the
tracking cams or snubber tracking brackets.
I
TRACKINGBRKTS
TRACKING CAM
SNUBBER TRACKING BRACKET
ALIGNMENT
HOLES
Snubber tracking brackets are located near the end
of the conveyor on the return belt snubber and near
the middle of noseovers. Tracking cams are located
on the end pulleys, the drive snubber, and near the
middle of noseunders.
CAM
BRKT
CAM
BRKT
CAM
DR
IVE
NO
SE
UN
DE
R
NO
SE
OV
ER
BRKTLOCATION
Turn the tracking cam with a 3/8” ratchet as shown:
TURNCAM
3/8" RATCHET
3/8" EXTENSION
NO SOCKET
Tracking scenarios:
(Note: “FLOW” refers to belt flow direction, not
necessarily product flow)
FL
OW
BE
LT T
RA
VE
L
BE
LT
TR
AV
EL
FLO
W
FL
OW
FL
OW
BE
LT T
RA
VE
L
BE
LT T
RA
VE
L
FL
O
W
BE
LT T
RA
VE
L
FL
O
W
BE
LT T
RA
VE
L
END PULLEY,
NOSEUNDER SNUBBER
NOSEUNDER SNUBBER
END PULLEY,
DRIVE
SNUBBER
SNUBBER
DRIVE
RETURN SNUBBER,
NOSEOVER SNUBBER
NOSEOVER SNUBBER
RETURN SNUBBER,
TRACKING
NOTE
Belt moves toward the end of the pulley
that it contacts first.