MHS Boilers Alpha Jetstream MD, Installation And User Manual

Page: 18 / 28

5. Place boiler body insulation (117) squarely on top of boiler block. After placing the
insulation, secure both ends of the insulation blanket to lower staybolts by using four
retaining springs(156).
6. Fit left and right rear insulation panels(157) to smokehood (11) and secure by pushing
onto the M10x105 studs (145). Fit base insulation panel (93) underneath the boiler block.
7. Fit side casings (148,149) passing M10x105 studs (145) through the holes on the return
folds of the casing, hanging the front edges of casing onto the upper casing support (155)
and fixing the front lower end of the casing to the free end of the lower staybolt (7). Fit side
casings by M10 nuts (153) and washers (152) to the M10x105 studs (145), by M6 set
screws to the front upper casing support and by M12 nuts and washers to the lower
staybolts.
8. Fit the top casings (163,164) onto the side casings by special pins (162,161).
9. Fit the rear panel by self tapping screws (160) to the return folds of the side casings.
The rear panel is in two parts - upper (158) and lower rear (159) panels.
ASSEMBLY INSTRUCTIONS
M10x105 studs
Insulation
springs