5
10.
Rear Wheel Axles
[See Maintenance Schedule]
The rear wheel stub axles need to be lubricated regularly. Remove the rear wheels by depressing
the spring clip and at the same time pull off the wheel. Apply Petroleum Jelly or light grease to
the stub axles. Use a very small amount as the grease can attract sand. If you play in sandy
conditions you should clean your axle and regrease fortnightly.
To refit the rear wheels you will need to align the wheel’s four sided slot to its equivalent on the
buggy to ensure the wheels are properly engaged. Ensure that the wheels are put on the correct
side ‘L’ and ‘R’ [see part 6, page 12].
11.
Clutches – SL150c and SL350c
[See Maintenance Schedule]
The rear wheel clutches need to be cleaned and checked to confirm they function correctly and
should be replaced as per the Service Schedule. Remove the rear wheels by depressing the
spring clip and at the same time pull off the wheel. The clutches can then be removed by pulling
them off the axle.
If you play in sandy conditions you should clean your clutches every three months. Clean the
clutches by immersing them in kerosene to remove the sand and grit. Then apply a small amount
of Petroleum Jelly or light grease inside of the clutch.
Place the clutches back on the axles to check that they function correctly. Try and turn the Right
Hand clutch in an anti clock wise direction – if you cannot it is functioning correctly. Try and turn
the Left Hand clutch in a clock wise direction – if you cannot it is functioning correctly.
12.
Upper & Lower Bag Straps
[See Maintenance Schedule]
The upper and lower bag straps should be replaced as per the Service Schedule. The upper bag
strap can be replaced by:
1. Removing the left and right hand straps form the upper bag support.
2. Undo and remove the screws holding the strap in position on the bag support
3. Remove and replace both bag straps.
4. Insert bag strap securing screws.
The lower bag strap can be replaced by unclipping it from the bag support and installing the new
bag strap.
13.
Correcting the Alignment of your Motorised Buggy
[See Maintenance Schedule]
RIGHT
LEFT
If during use, you find that the buggy veers to the right or left,
please follow the instructions below to correct this problem:
1. If the buggy veers to the left, face the front wheel of
the buggy and use the Allen key provided to screw the
right bolt clockwise or the left bolt anti-clockwise.
2. If the buggy veers to the right, face the front wheel of
the buggy and use the Allen key provided to screw the
left bolt clockwise or the right bolt anti clockwise.
Test run the buggy and repeat the process until the buggy
runs straight.
