5
Make sure the receiver-collar is NOT turned off by checking the signal icon on the
transmitter. If the receiver-collar is turned off, the transmitter will not be able to send
out a signal to it and the signal icon light will not flash accordingly.
Make sure the dog you need to train is correctly selected. For example, if the first
dog is currently selected, the second dog will not react to any commands you send
from the transmitter. You can only control one dog at a time if dogs 1 or 2 are
selected. To select both at the same time, select 0.
Re-programme the receiver-collar and intensity level and try again.
The receiver-collar does not seem to take a charge:
Make sure the charger is plugged into the mains supply tightly and that the charging
end is plugged into the charging hole fully. During charging the red LED light on the
receiver-collar should stay on.
My dog does not respond when I issue a correction:
Test the receiver-collar according to the instructions above to make sure each
stimulus is functioning.
Make sure the correction prongs are positioned properly and that both prongs are
making contact with
the dog’s skin and that the collar is snug.
Increase the intensity level of the correction.
Safety Guidance
There are no user-serviceable parts so please do not open the shells of either the
collars or the transmitter. You could easily cause damage or harm the waterproof
feature. Tampering will also nullify the warranty.
In order to ensure the submersible feature, the waterproof rubber charging lid should
be plugged in tightly.
Only use the supplied NZ approved adaptor to charge the receiver-collar otherwise
damage could occur.
Do
NOT
to touch the metal prongs on the receiver-collar
to test it. To test the shock
correction, please use the supplied testlight kit.
If there is water in the charging hole, please dry it before charging the receiver-collar.
