4
This product is not recommended for aggressive or elderly animals in poor health or
animals otherwise unable to withstand the stimulus.
CAUTION: Any collar worn for extended periods can cause a condition similar
to bedsores, known as Pressure Necrosis.
To reduce the possibility, you must do the following:
Never leave the collar on the dog for more than 12 hours per day.
Examine the dog’s neck daily for any signs of a rash or a sore.
Supervise your dog during the first 2 days of training.
Check the collar fit to prevent excessive pressure. You should be able to insert one
finger between the collar strap and your dog’s skin.
Safety
To maximise the effectiveness of the MGG GT-211 remote training system and
safety of your dog, check the fit of the collar frequently and readjust the position of
the
electrodes on the animal’s neck whilst checking for signs of irritation or
discomfort.
If signs of skin irritation are noticed, immediately discontinue use and apply antibiotic
ointment to help heal and sooth the area. If the condition persists beyond 48 hours,
please seek the advice of a veterinarian. Such side effects are extremely rare and
are generally caused by a more serious existing condition.
The collar is not intended to be left on a dog for an extended period of time without
supervision and doing so can lead to health problems. The conservative
recommended time limit without supervision is 12 hours.
Wash the dog’s neck area and the correction poles as often as needed to keep the
area and poles clean. Make sure the straps are clean for the best performance. The
straps can be removed for cleaning but must be re-fitted in the same position.
Common Problems & Solutions
When pressing the B-beep button
NO BEEP
Make sure the receiver-collar is fully charged. A low charge will cause the receiver-
collar to work inconsistently.
Follow the instructions and synchronise the receiver-collar to the transmitter.
Make sure the transmitter battery is well charged. A low battery will disallow the
remote to emit a strong enough signal every time.
Make sure the transmitter is not set at the ZERO level.
