13
UG-015
10.0
Product Notes.
1.
Ensure that Gangway Ramps, overshoe adaptors and Laddersafe platforms are not damaged or
distorted and that the correct Laddersafe platform, connecting pins and nuts/bolts have been
provided prior to use (please refer to MGF Technical File). Always replace damaged components.
2.
Always install the Gangway Ramps and the Laddersafe platform from a position of safety. If working
from an unsupported edge a full risk assessment should be carried out for installation. Once the
Laddersafe is installed ensure the clamping bolts are fully clamped and it cannot be lifted, slide or
rotate prior to securing the Gangway Ramp.
3.
Ensure the Gangway Ramp is securely connected to the Laddersafe platform and that all 20mm
diameter pins are secured using a r-clip and the supplied securing plate.
4.
Ensure when connecting Gangway ramps together than the M16 nuts and bolts are sufficiently
torqued and that retaining clips are provided for the integrated pins. Gangway Ramps should be
connected together prior to securing to the Laddersafe platform.
5.
MGF Gangway Ramps are modular and no more than 3 ramps should be connected together.
6.
The maximum achievable angle of 17.5° must not be exceeded, which can cater for a maximum
vertical height of 0.5m per ramp, up to a maximum of 1.5m for 3 connected ramps.
7.
MGF Gangway Ramps are designed for man access to an MGF Laddersafe system and should only be
used by a single person and should not be used to transport/store equipment.
8.
Laddersafe platforms should only be fitted to MGF excavation support systems using the clamps
specified. The customer must ensure that these support systems are installed in accordance with MGF
guidelines and are sufficiently robust and stable to act as an effective edge protection support.
9.
It is recommended that 2 operatives are used to install the Gangway Ramp overshoe adaptor and that
this is installed prior to installing the Laddersafe platform onto the sheets.
10.
Gangway Ramp overshoe adaptors must only be affixed to the back face (retained side) of the
Laddersafe platforms. Gangway Ramps are not designed for access within the excavation – and are
only suitable for access to a Laddersafe platform should the upstand be restrictive otherwise, or the
ground around the installed Laddersafe platform be sloping away from the sheets/box panels or be of
a poor quality.
11.
Be careful of finger trap hazards during the installation, ensure suitable PPE is worn throughout the
installation and assembly.
12.
Always consult with MGF for suitability of the system for any specific installation. MGF Laddersafe
must not be clamped to trench sheets less than 6mm thick, or piles in pure cantilever or cantilevering
more than 1.5m above a waler rail/brace. In addition, it is essential that the excavation support
system (that the clamp is attached to) is installed robustly and fully supported by the ground (no
voids/weak ground present).
13.
Take care when storing Laddersafe and Gangway Ramps onsite as they can be easily damaged. Always
stack components on timbers and lift using suitable chains/plant.
14.
Ensure that the Gangway Ramp is adequately footed before use on firm, level ground and that the
Ramp cannot sway, vibrate or deflect excessively during use.
15.
Prior to use it is recommended to use the supplied safety chain to close of the gap between the
Gangway Ramp handrail and the handrail on the Laddersafe platform.
16.
Removal is a reverse of installation.
