INSTRUCTION MANUAL
MG MOTOR
22
4. Thread the incoming cable through the large hole in the center of the rubber plug of the cable,
compress the terminal, and fasten it to the wiring connector with a screw (torque 1.8 Nm, there is a
wiring comparison table in the shell).
5. (Optional) If you need to install a network cable (depending on the configuration), you need to
cut through the channel on the left side of the cable, insert the network cable, and plug it into the
corresponding interface.
6. (Optional) If you need to install a SIM card (depending on the configuration), insert the SIM card
directly into the corresponding connector.
7. (Optional) If an external shunt trip is required, the two connecting points reserved according to the
indicated position of the product shall successively connect the shunt trip control circuit with a voltage
not higher than 230Vac and a current not exceeding 1A in the control circuit, as shown in the following
figure:
Figure A-5 Fixed Socket and Socket holder bracket
