21
MG MOTOR
INSTRUCTION MANUAL
Figure A-3 Wall mounting height
Figure A-3 Drilling template
2. As shown in Figure A-4, the center distance of the wall drilling hole, place the drilling template at a
suitable height, and mark the punching position on the wall with a pencil.
3. Use a Ф8 drill bit for the wall to open 4 holes with a depth of 70mm, install an Ф8*60 expansion tube,
and use two M6 self-tapping screws to fasten the wall mount to the two holes under the wall, and
directly tighten the two holes on the top. Insert two M6 self-tapping screws. Note that the screw head
protruding height is 7mm, as shown in Figure A-5.
