8
Tilt function
Warning! Do not carry out this
adjustment while a user is placed in
Meywalk® 4.
By means of the tilt function the
user’s posture can be changed. Turn
the middle thumb screw to tilt the
support. The thumb screw is located
at the front of Meywalk® 4. While
turning the screw, you can change
the angle of the trunk support and
seat up to 15°. The tilt function is
continuously adjustable.
Getting in and out
Featuring a unique lifting and
lowering system Meywalk® 4 has
made it easier for the user to get in
and out. Grab the front of the swing
bar with both hands and tip it up.
This way the seat will be lowered
approx. 11 cm for Small, 13 cm for
Medium and 22 cm for Large. When
the user has been seated, close the
trunk support and pull up the rear
stop. The seat is lifted by pushing
down the swing bar until it locks with
an audible click. The integrated
gearing in the lifting and lowering
system means that the downward
pressure need only be about one
third of the user’s weight
Rear stop
The rear stop should always be
closed in the upright position when
there is a user in Meywalk® 4. Pull
the rear stop backwards out of the
seat and turn it upwards. Now you
can push it down into the locked
position. Repeat the procedure in
reverse order to open the rear stop
again.
The rear stop behind the seat can be
adjusted in depth. First lift up the rear
stop and tilt it backwards. This
reveals an Allen screw inside the U-
profile When the Allen screw is
loosened, the rear stop can be slid
forwards or backwards in the external
tube. After adjustment, re-tighten the
Allen screw.
